I am currently having a problem with my WD TV Live hub to where the led keeps blinking in 4 short, 2 long, and 3 short blinks. I have it connected with HDMI to my TV and have never had an issue until now. I have tried resetting the button on the bottom, turning off and on the tv as well as the unit, I am not sure what else to do.
Can anyone help me with this problem? I really want to use my WD TV ! thanks 
The subject Joey linked to is actually not the error code. That particular problem was caused by a faulty power switch on a large batch of Hubs.
The Three / Three / Three pattern, as documented in the manual, is a signal of failed hardware diagnostics during bootup.
Ok, Tony … so what’s your helpful suggestion then for kylecop1 ? if you have any ?
I would say the same as your now edited one at post 2.
any other useful tips? I have no warranty left on my product
This might help if it is the switch…
We have already been there with the switch. That does not give an error code as described.
From the manual.
Three short flashes followed by three long flashed followed by three short flashes—A system diagnostic failure has occurred.
This is SOS in Morse code.
well, thanks for the help I just had to order another one.
| Forums | News and Announcements | Register | Help | Forum Guidelines |
Copyright © 2021 Western Digital Technologies, Inc. All rights
reserved.
|
Trademarks
|
Privacy
|
Community Terms of Service
|
Site Terms of Use
|
Copyright
|
Contact WD
|