Die Platten werden nicht als Physical Drive erkannt , sondern nur als Logical Drive.
Vermute das liegt daran , daß die Platte nur im US-Dockingstation betrieben werden unt nicht intern an den PC angeschlossen sind.
Wenn ich die Platten mit einem anderen SMART-Diag. auslese wird eigentlich alles als OK gemeldet.
Hier mal ein Auszug von HDDScan; weiß nicht obs was bring:
WDC WD60EZRX-00MVLB1-WD-WX31D3409486-SMART.mht
HDDScan S.M.A.R.T. Report
Model: WDC WD60EZRX-00MVLB1
Firmware: 80.00A80
Serial: WD-WXXXXXXXXXXX
LBA: 11721045168
Report By: HDDScan for Windows version 3.3
Report Date: 19.11.2014 22:52:11
Num Attribute Name Value Worst Raw(hex) Threshold
001 Raw Read Error Rate 2002000000000000-0000051
003 Spin Up Time 2072020000000000-21CA021
004 Start/Stop Count 1001000000000000-015A000
005 Reallocation Sector Count 2002000000000000-0000140
007 Seek Error Rate 2002000000000000-0000000
009 Power-On Hours Count 1001000000000000-02A0000
010 Spin Retry Count 1001000000000000-0000000
011 Recalibration Retries 1001000000000000-0000000
012 Device Power Cycle Count 1001000000000000-0073000
192 Emergency Retract Count 2002000000000000-002F000
193 Load/unload Cycle Count 2002000000000000-092F000
194 HDA Temperature 12011132 C 000
196 Reallocation Event Count 2002000000000000-0000000
197 Current Pending Errors Count 2002000000000000-0000000
198 Uncorrectable Errors Count 2002000000000000-0000000
199 UltraDMA CRC Errors 2002000000000000-0001000
200 Multi Zone Error Rate2002000000000000-0000000
Ansonsten werd ich wohl testweise die Platten nacheinander mal intern anschließen und dann nochmal mit WDLG testen.