WD Driver Enabler reports: Config file not found

[johnlgoodman]

WD2002FYPS-02W3B0 failed in WDX4000. Tried to replace with WD2002FYPS-01U1BU, Sentinel says “Invalid drive”. Downloaded WD Drive Enabler and followed the instructions to run from a folder on Sentinel. After prompt to proceed, Drive Enabler says: “Config file not found!”

[Gramps]

I guess it is looking for whielist.xml. May be a hidden file

[johnlgoodman]

Any idea what the “whitelist.xml” file should look like? properties? format? example?

[Gramps]

Expanding DX4000 HDD List

I have recently ran into where two brand new units from WD came with HDDs that are actually not supported.  While the units ran flawlessly, when we were asked to repurpose them to another department we bagan wiping the HDDs to a clean slate to then recreate storage, and eventually install the OS from scratch using the recovery ISO.  After many head scratching frustrated hours of Invalid config, Invalid Drive Count, and a few others that I ran into only once or twice.  I finally looked into the r…