WD Blue 2TB- Boot Read Error 50% of the time

High all,
I just joined the forum. I finally added a WDC Blue 2TB SSD to replace my 2 TB hard drive. The upgrade went very smoothly after I stopped trying to use the Acronis software and used Aomei Backer Upper instead. The system works well with one minor annoyance. About 1/2 the time when I do a cold boot in the morning, I will get an error message that there was a disk read error and to press CTL-Alt-Del to reboot.

So far, the reboot always works and Win 10 comes up really quickly.

I’m not sure if I should ignore this or try to repair it. Is it a marginal cell in the memory?

Any suggestions would be most welcome.