Set/Verify USB Backup Time

I am using USB HDD’s to backup my data for Disaster Recovery. I would like to know when the backup is done. I don’t see a place to specify when it is done nor a setting that controls the time.

Hi Chuck_Balogh,

You can have a look at these KBA’s;

https://support.wdc.com/knowledgebase/answer.aspx?ID=9883&lang=en
https://support.wdc.com/knowledgebase/answer.aspx?ID=3828&lang=en
https://support.wdc.com/knowledgebase/answer.aspx?ID=19516&s=

Thank you for your response. Sorry for the long delay in my reply but this has been a lower priority.
Unfortunately, the SMareWare solution is NOT what I am looking for. SmartWare allows configuration of the WD as the TARGET drive for backups. I am trying to use External HDD’s as the TARGET drives. I am doing this for disaster recovery. Do you have any other suggestions?
Regards,