After restarting the NAS after a fresh new firmware install the power led is blinking red all the time. I can access my 2 disks so I dont know what it is about.
This is what I can see.
and what the heck is geassemánnu ?
Volymfel
Det går inte att komma åt volym 1 på enheten. Kontakta vår kundtjänst.
After restarting the NAS after a fresh new firmware install the power led is blinking red all the time. I can access my 2 disks so I dont know what it is about.
This is what I can see.
and what the heck is geassemánnu ?
Volymfel
Det går inte att komma åt volym 1 på enheten. Kontakta vår kundtjänst.
A “power cycle” is the physical process of completely disconnecting the device from power and interface cables and allowing it to rest for at least 10 minutes. This is also called a “cold boot” and is able to address specific issues by resetting power distribution from scratch.