Rebuilt G-Raid Studio but configurator is still showing [D]

I have a G-Raid Studio Thunderbolt 2 set up as Raid 1 (on a mac).

A few days ago one of the drives appeared as [D] in the configurator, so I rebuilt the bad drive from the good one, or so I thought.

Now the configurator is showing a green check-mark, the two drives are appearing as one in the configurator and on my Mac, but the name of the drive in the configurator still carries the [D].

So, did I actually rebuild the good drive from the bad? Or is this some glitch?

I’ve had to do this once before and everything worked fine.

I am spot checking the contents of the rebuilt Raid (all photos) ands so far I have found no issues. Everything appears present, up to date, and no missing images (looking through Lightroom).

Any ideas?

thanks
Eric

Have you since restarted your Mac and drive to see if it still shows with the [D]? The best course of action would be to offload the data just in case and instead of rebuilding, just change it to RAID0 and back to RAID1 and erase it in Disk Utility again to start over.