Need some help with this strange scenario.
I recently had to take out my each of my four WD Sharespace disks and reformat them (fill them with zeros) because the dreaded “XML error: no wixnas object found!” message.
Now three times in a row, the rebuilding finishes successfully, and the default DataVolume is created, but after about 30 minutes a red LED starts flashing on the unit and I get the message “DataVolume does not exist” within the logs.
And when I reboot the unit from the System page of the unit’s web URL address, it begins rebuilding the RAID5 again!
Am i missing a step or doing something wrong?
Why does the unit finish rebuilding the RAID5 successfully only to show this failure message 30 minutes after?
I’d post some logs but the ■■■■ thing is rebuilding again as i’m writing this post.
Any help greatly appreciated.
Hi kabalizo,
Maybe you should try contacting WD’s Technical Support about this.
To Contact WD for Technical Support
https://support.wdc.com/support/case.aspx?lang=en
The link below will allow you to call support.
