MBL probably bricked? i cannot understand

Hi to all,

after a factory reset the mbl signs 0gb available on 0tb suitable, but the hard drive inside is alla clean. diagnostic test is stuck at 90%…, how can i solvce this problem?

seems that the mbl is little weak… .

Welcome to the WD Community.

See if the following link helps:


as far as i can understand i have to disassembly the mbl and manually work on it… .that’s no good

If unit under warranty, please contact WD.

Otherwise, the unit might be in  a weird state assuming there is not hardware issues. If you want to recover it, there are only DIY guides.