Hello . i use the guide 2 to setup MBLD,new empty drives,i only install A drives ,and put it back.
after restore the factory settings (quick and full all tryied),but there still have a smart fail error message .
i search some meeage on the forums, is this caused by samrt diable ? i use smartctl -s on … to enable the /dev/sda and /dev/sdb…is this correct? the script can’t auto enbale the drives samrt?
i found the script can’t format the /dev/sda4…after install and full factory restore. use SSH back to check the drives,
i use “parted” to check is drives partition is ready…sda4 still don’t have the file system(should be ext4?) please help to check ,is this normal? after i rebuild the raid1.then go normal as below
Number Start End Size File system Name Flags
3 15.7MB 528MB 513MB linux-swap(v1) primary raid
1 528MB 2576MB 2048MB ext3 primary raid
2 2576MB 4624MB 2048MB ext3 primary raid
4 4624MB 2000GB 1996GB ext4 primary raid
