Glitchy remote control with new firmware

does anyone else have a remote control that “double” sends commands with only one press of the buttons…what I mean is when I press say “up” once to say go to the netflix icon, it will go up two levels…very annoying…had to go back to 1.0.3 to get rid of this

Yes, I have seen this problem with all of the firmwares, and it does seem to change a bit with the various firmwares that were released. Usually though, by controlling how long you press the buttons, you can get to the point where you learn how NOT to make it send a ‘double’ command.

I eventually went back to 1.03.10 to get rid of the problem but of course this means I don’t get any of the new stuff.