Hi I purchased two G Raid Studio drives, 8T with the intention to configure to Raid 1. So my data is mirrored between two 4T’s on the drive in each unit.
Set up the first one a few months ago and all has been great and fast! Just went to configure the 2nd one today. Plugged it in to my MBP, drive showed up on the desk top, went to the G_RAID Studio Configurator 1.0.0. Ran it set to RAID 1. All seemed to be going good, had me rename the drive which I did and then had me finish. When the dialog box went away I saw a Mac dialog box hiding behind that said “The disk you inserted was not readable by this computer” with an Initialize, Ignore and Eject option. I chose eject figuring that G Raid Studio Configurator just told be all was good! So I shut down and then rebooted and received the same message. “The disk you inserted was not readable by this computer” This time went to ‘Initialize’ was taken to Disk Utility where the drive does not appear??? I am now lost in no mans land and can’t get the drive to show up anywhere. Stuck Please help! thanks