DX4000 Windows update reboot loop

I have several of these DX4000 units and have had several issues, but this one has me pulling out the little bit of hair I have left.
The unit keeps rebooting. I can use VNC to get on the unit, but only after it has fully started and the updates are in process. I cannot figure out how to stop them from running after it reboots.
There is an added joy with the unit saying I have a bad hard drive. No problem. Just look at the unit and it will have a red light showing which drive is bad. Well, that is what is supposed to happen. Notifications don’t tell me which is bad, either. Looks like #3. I replace it and the unit will not start. Put the old drive in and away it goes…back to windows updates and rebooting…

Hello,

I recommend you email support about this issue.