Cen't set network cable manual address or obtain an address from dhcp

Hi everybody,

I’m trying to make the cable connection working without success.

I’m sure that my network switch is sending the addresses (every other PC or device is connecting). Also I can use the wireless connection with the wd tv (eith the usb tp-link wireless), but it is impossible to make the cable connection working, with the manual address setting and even with the automatic address setting.

The switch light is blinking, and when i try to connect it is (as expected) powered off and the lighted again.

Is this (another) hardware problem with my WD TV (I’ve just changed it because the hdmi broke up) or is there something I should check?

Thank you so much.

Raoul

Did you tried something simple like resetting the router after changing the setting on the WDTV?