Blinking Blue light,yellow light

I noticed I could not connect to MBL yesterday and after physically looking at the unit, I have a blue light for approximately 7 seconds and it goes yellow for a second, then back to blue. I did a hard reset with no change. I then changed the cat 5 cable and switched ports. Still no joy. I can hear the drive spinning up, but I can’t connect. What am I missing?

Hi Bareynolds,

Try to perform 4 second reset on the drive and check if the issue still persist. Please refer to the link given below for more information.

I also have the same issue, tried everything so far, nothing works.
As a last resort I bought an exact same internal drive to swap out the print, i think that one is broken since I cannot connect in anyway with the HDD, even trough a direct SATA cable