Auto start on application of power

I have a 4TB Sharespace NAS.  It has been working great for the most part.  One issue I am trying to figure out is how to get it to automatically start or automatically go to last state if there is a power failure and then power is re-applied to the device.

As it stands, if the device is on and running, and then there is a power failure, when the power comes back on my systems all boot back up, servers start up, but the NAS devices stays powered down.  This causes mapped drives to fail to connect when the servers start up. 

I would like the device to either boot up when power is applied, or better yet, go to last known state when power is applied.

Where can I set this option.  Note that I am comfortable with command prompt/SSH options as well.



Hi, unfortunately this option is not available.