Hello.
So i bought new WD Black WD2003FZEX 2TB 3.5" SATA/600 and it’s very simple… disk is restarting. It is showing, it’s not and it’s showing again. It’s doing it over and over again so i can’t do anything on it. Well sometimes it will run for some time - it did install TES:O without problems, but that was one-time thing.
WD Data LifeGuard Diagnostics - Extended test.
| Test Option: | EXTENDED TEST |
|---|---|
| Model Number: | WDC WD2003FZEX-00SRLA0 |
| Unit Serial Number:**** | |
| Firmware Number: | 01.01A01 |
| Capacity: | 2000.40 GB |
| SMART Status: | PASS |
| Test Result: | FAIL |
| Test Error Code: | 08-Too many bad sectors detected. |
| Test Time: | 12:04:51, October 21, 2018 |
| Test Option: | EXTENDED TEST |
|---|---|
| Model Number: | WDC WD2003FZEX-00SRLA0 |
| Unit Serial Number:**** | |
| Firmware Number: | 01.01A01 |
| Capacity: | 2000.40 GB |
| SMART Status: | PASS |
| Test Result: | FAIL |
| Test Error Code: | 08-Too many bad sectors detected. |
| Test Time: | 12:11:54, October 21, 2018 |
I did try changing sata cable, sata slot, power cable. Well my old WD blue drive which i tried to replace was working fine on same cables.
Temps are 21-30C on extended noise. Some grinding noises at the start of extended test but i heard that weird noises are nothing special with black version.
On Crystal…
Disk went full retard on-off-on-off at writing. Reads without any problems.
Some potato scores.
+PSU SilentiumPC Deus M1 80Plus Bronze 550W
