1/1 : English AAC - Appears between every loop of movie

I have one movie (MP4) in the media folder that I want to loop over and over again. All is well, the movie plays, nice smooth animation, looks good. The problem is that at the start of every loop of the movie a message shows up on the screen that says "1/1 : English AAC ". I have looked and looked through the menus and cannot for the life of me figure out how to get rid of it.

Any help would be highly appreciated.

I forgot to click email me when someone replys, so I’m doing it now!

What firmware do you have on the WDTV and what model do you have?

You could put the movie in the root of a attached USB drive and then set the WDTV to autoplay. When the WDTV starts up it will automatically start the movie without the annoying message.

My bad! I was wrong. I do indeed have a USB with the movie on it! It’s not on the unit.

I’m not sure of the firmware version as the unit is off site at my client’s office. Netx time I’m up there I can get the units (there’s actually 2 doing the same thing) and check the firmware. I don’t think that’s it, but should I update it anyway?

Any other suggestions?

Thanks in davance!