I am doing a reset to factory defaults with two brand new 4tb hard drives (other two bays are empty). For the past 48 hours the display reads “Recovery Started”. My PC was showing the recoverty status as formatting, however the PC did and update and I lost visibility to monitor the recovery status…

No worries mate. From a PC remote to the server desktop start>run>mstsc User Administrator Pass Whatever you set on the server start>run>diskmgmt.msc You should see one disk, So you got 60gb at the front and a bunch after that. Not sure how far it got. But you may need to create a partion,…

WD Community

Recovery Started DX4000 now 48 hours and counting HELP!

WD Legacy Products Sentinel Products

Gramps May 3, 2014, 7:54pm 8

No, you can’t do that

1 Like