Mionet restarting on it's own

WD Legacy Products Other Network Drives
10

  1. Stand by Mode - do it true amdministrator console - WD discovery - Configure - login (admin/admin) - Advanced mode  - Advanced - HDD Standby Enable

  2. chech if Mionet is Disable - WD discovery - Configure - login (admin/admin) - Advanced mode - Network - Remote Access - Status STOPPED

I recomend you, if you have old firmware 1.1.16 or 1.1.18 to totaly disable Mionet and Twonky (you did it now), becouse you will restart manualy the WD MBWEII every ± 20 minutes when you make bigger data transfer (5-10 GB). problems with Buffer leak and in firmware, … You will be crazy with this situation and the device will be not possible to connect from outside, becouse it will be not accesable.

  1. if you would like reverse the porcess just use this this lines…

mv  /root/S9M_mionet /etc/init.d/

mv  /root/S97twonkyserver /etc/init.d/

mv  /root/cvm /usr/mionet/bin/

mv  /root/changeNotifySocket /usr/mionet/

mv  /root/miocrawler /usr/mionet/plugin/miocrawler/

then reboot your NAS with

reboot

My advice is disable Mionet and Twonky and push on WD to release new firmware, then you can enjoy your NAS with full functions :slight_smile: