The data on the drive is less than 120 Gb as you can see on the supplied screenshots. And I have downloaded newest Acronis under the product page as the supplied key links to.
I have tried both manual and and automatic mode, but both have same problem. I cannot select the target disk.
I cannot see anything about incompatible chipset on the FAQ page: http://wdc.com/en/products/products.aspx?id=1190#Tab2&Tab10
And I expect that the chipset on the WD Black2 is supported. This is the disk which I cannot select.
The software runs fine in windows. However I cannot select my new WD Black2 as target.
Please read the complete thread and check my attached screenshots.