Sorry, I don’t see any image.
Anyway, ISTM that the driver is installed, and Windows is detecting the bridge chip in the enclosure, but not the drive behind it. Perhaps the BIOS, too, is only seeing the enclosure, or does it actually identify the drive inside?
You could try hooking up the enclosure without the drive to see if it is detected any differently.
Try reducing the interface speed to 1.5Gbps by adding a jumper across pins 5&6.
You could also try disabling SSC (Spread Spectrum Clocking) by adding or removing the jumper from pins 1&2, depending on the model.
Jumper Settings Info Sheet:
http://www.wdc.com/en/library/eide/2579-001037.pdf
WD SATA Hard Drive Quick Install Guide:
http://www.wdc.com/en/library/sata/2079-001042.pdf
