I already did. I used smartmontools and aida64. Same result. I doubt the software is the issue.
Also, I tried this with two different mainboards (Asus P8P67 Deluxe rev2.0 and Gigabyte GA-P35C-DS3R). Same result here as well.
Anyone running the same HDD as me, could you check your smart values as well and post them here? Since I got three drives with the identical issue, it might be an issue with the whole RE3 1TB series.
Edit: Just like I thought… it certainly is counting the hours, but its loosing those from time to time. log of the same RE3 1TB from above, just one day later:
ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE
1 Raw_Read_Error_Rate POSR-K 200 200 047 - 0
3 Spin_Up_Time bleep --K 253 253 039 - 1233
4 Start_Stop_Count -O–CK 098 098 050 - 2411
5 Reallocated_Sector_Ct PO–CK 200 200 051 - 0
7 Seek_Error_Rate -OSR-K 200 200 046 - 0
9 Power_On_Hours -O–CK 100 100 050 - 88
10 Spin_Retry_Count -O–CK 100 100 050 - 0
11 Calibration_Retry_Count -O–CK 100 100 050 - 0
12 Power_Cycle_Count -O–CK 098 098 050 - 2368
192 Power-Off_Retract_Count -O–CK 200 200 050 - 480
193 Load_Cycle_Count -O–CK 200 200 050 - 2405
194 Temperature_Celsius -O—K 112 090 034 - 38
196 Reallocated_Event_Count -O–CK 200 200 050 - 0
197 Current_Pending_Sector -O–CK 200 200 050 - 0
198 Offline_Uncorrectable ----CK 200 200 048 - 0
199 UDMA_CRC_Error_Count -O–CK 200 200 050 - 0
200 Multi_Zone_Error_Rate —R-- 200 200 008 - 0
||||||_ K auto-keep
||||| C event count
||||_ R error rate
||| S speed/performance
||_ O updated online
| ______ P prefailure warning
